bj2004

Oil and filters sound fine is the rest set for all wheels ?

well if you dont want it and it can be driven i can offer it a good home

Yes sorry thats a good start remove the radio and see what antenna is connected in the galaxy radio antenna is pretty poor but does work you may find that the one on the roof does come down to the radio and will probably be better than the one in the rear window I believe the galaxy uses a signal booster it may be this isnt working Mirez will know better than i if you need more help just ask

Its Probably a two way coms or data antenna You could always use it for a cb radio

Ford Know as much about the galaxy as as i know about footbal zero ask on here what exactly are you trying to achieve ?

yes looks that way to me also perhaps you could find a signal from the speed sensor system you might have to build a little amplifier to or speak to the manufacturer sure theyve had this befor

Just had to remove my N/S Head lamp because while fitting a new Lamp the spring retaining clip came off after looking on this site for instructions the job was a piece of cake but did struggle finding one of the monting screws (outboard rear ) so thought i would post a pic to show them Its easier to remove headlamp to change lamps than mess about with the silly access and plastic covers no more cut hands for me hope this helps john

try fitting a length of tube to your vacume cleaner and sucking it out

if the sensor cable on the brake pad has been routed tightly it can snap as pad wears down happened to me once would fit in with the hard breaking

Has a cable to a sensor broken ?

Not sure but i think the yelloy one is cd changer just get a small speaker with wires on and check your units working

Mine is 437.92 Mhz

idle air control valve would be a good place to start sits behind the rocker box to left off ctr held by 2 alan keys and a plug Have fun

This worked for me http://www.ebay.co.uk/itm/FORD-GALAXY-VW-SHARAN-1-9-TDI-PD-ENGINE-OIL-FILTER-/300375904033?pt=UK_CarsParts_Vehicles_CarParts_SM&hash=item45efcc8f21

just had this on my car started off like wheel out of balance then got worse over time it was splines on drive shaft breaking down its well documented on here i believe the culprit bolts on to power take off on gearbox cost me

Technicaly lack of air due to a blocked filter would cause fan to run faster as there is less resistance to air flow hence resistor pack failing starting to sound like motor impeeded

hmm i would agree switch sounds fine you need to look at motor might be obstruction to blades or dry bearing causing it to overheat and cut out

No at those values i would expect some differences the pack sounds good unless you can see or feel that the fan can turn freely id cant help anymore unless the switch is faulty good luck

if this helps the readings for a new front blower resistor pack looking at green connector at bottom are counting pins 1-4 from left 1-2 2.7 ohms 1-3 1.2 ohms 1-4 1.0 ohms 2-3 2.3 ohms 2-4 3.2 ohms 3-4 1.6 ohms you should be ok as long as theese are within 10-20 % have fun

No you need the one for the front http://www.ebay.co.uk/itm/170740032050?ssPageName=STRK:MEWNX:IT&_trksid=p3984.m1497.l2649

The component across the two owter resistors yes

Hi just removed the front fan resistor pack due to fan only working in position 3/4 the resistors look fine no hot marks has anyone got the correct readings for resistance values accross the 4 pins ? thanks

Interesting thread i hope someone can shed a little light on it

Check for broken wires in drivers door gaitor big brown one is favourite

no try starting with jump leads when started check alternator is charging min 13.6 v at battery then after a couple of hours stood you should still have a reading of over 12v if less battery u/s check all earth connections after trying to start are any hot ? check also starter moter connections at same time hot terminals show bad connection