dlt1617 Posted February 19, 2012 Report Posted February 19, 2012 Hi I'm hoping some one can help with suggestions on this one! My Galaxy had to have the engine replaced as the turbo hydrauliced the engine causing a lacvk of compression on cylinder 4. The gearbox was swopped from the old to the new (well second hand one)engine, the car seemed to drive fine initially but did on a couple of occasions at idle do a bit of a split second shudder when sat at lights.Now the main problem, the gearbox suddenly seemed to be slipping excessively in first gear to pull away, after changing to second it would change to third and if you slowed down hold onto the gear and the start to shudder (like a manual car does if in too high a gear).The fault memory test shows 00652 Gear Monitoring fault, I've checked the speed sensor signals and the engine speed signal from the crank sensor almost matches the input speed signal on the gearbox until the car is put into drive when it drops to 0 and the engine reves can 1500 rpm and the input speed is only 200 rpm.The only other comment is the gear selector position switch has been adjusted but this only seemed to make the problem constant rather than working ok for a while when the fault memory was reset Possible selecvtor switch problem?? I wondered if any one else han had the same problem? Oly other thought was torque convertor??? Thanks for reading Dave Quote
chrispb123456 Posted February 19, 2012 Report Posted February 19, 2012 Was the fluid drained or changed as the first possible cause on rosstech site is fluid level? Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.