calvinsnetwork Posted January 10, 2011 Report Posted January 10, 2011 Hey Guys, Thanks once again for all your help. Managed to install the sensors, but have bit of a problem.Basically I want to put the LED display which came with it on the dashboard, does anyone know whats the best route to take through the car?My Reverse Box Control Panel is in the right rear compartment. Am I best to take it under through the right rear door, then drivers door, thenup towards the windscreen?Is there any better route to minimise showing of wiring. Cheers,Calvin Quote
George106 Posted January 10, 2011 Report Posted January 10, 2011 I have fed wire from o/s rear headlamp under sill covers and if you pull rubber seals, you may not need to undo seal covers at all. At the front, I fit display near side window vents and again if you pull rubber seals, there should be gap wide enough for the wire as well. Also would help, if you remove (slacken a bit) driver side kick panel (where bonnet lever is). George Quote
zorgman Posted January 10, 2011 Report Posted January 10, 2011 same as mine up the door seal then little panel on right off and tucked wire in small gap at windscreen/dash so display is smack in centre of window on dash Quote
calvinsnetwork Posted January 11, 2011 Author Report Posted January 11, 2011 Hey Guys, Thanks alot for your advice.I Appreciate it. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.