bigfoot

Hi all, I had new brake pads fitted in October o6 to my 2002 auto ghia gal, since when the "engine Workshop" warning appears. Garage (not Frauds) tried to rectify but only lasted a weekend. The warning now occurs after every start-up although you cannot set your watch by it. The heater plug warning light flashes continuosly after warning extinguished. The obvious question is "is there a simple method of re-setting this" apparently some of the wiring for the wear indication was removed on a previous brake service although the wires do come with the pads. I would point out that the 1.9 115 unit works absolutly fine, I would appreciate some advice :D

Thanks vr6galaxy, Not the answer I really wanted, but hey Ill give it a go, "I dont suppose you know the centre's of the clips by any chance"!!!!!! No ok I won't push my luck cheers. :(

The tailgate would not close properly on my o2 ghia and the alarm would not set nor would interior lights extinguish. I played around with the lock and found that in pushing the striker in to its second position that the interior lights would go out and the alarm would not set. I then noticed that the strike pin on the rear floor had loosened which is obviously the cause of the problem. Could someone please advise as to how on earth the the chromed trim plate is removed to gain access to locking bolts below the floor as I cannot make out how its retained.