Rear Speakers Are In (pictures)

[Guest BagPuss]

Well another part done! :)

 

Got another set of Hertz Speakers in! So thats's 6 and No I'm not fitting anymore! :lol:

 

Although someone was asking about putting them in where the other factory fit ones went. :D

So rather than try and cut the rear arch panels I went for the rear tail gate instead.

 

They sit quite high in the panel and are bang in the center of each of the 2 rear seats.

The Hertz Speakers are quite deep, so 10mm spacers were used just to raise them a little.

 

Anyway here are a couple of pic's I've just taken.

 

 

 

 

 

Oh and the Monitors are on route and should be here in a few days

So hoping for a little time to fit them!

Edited October 7, 2007 by NikpV

[cos 4x4]

i have done exactly the same as you matey have upgraded the speakers in the front doors to infinity 5 1/4" components 6.5" coaxials in the back doors and in the boot i have fitted infinity 6x9s in the boot door on 30mm spacers but wouldn,t recommend this as they still catch would have been better using a smaller not so deep speaker but the sound is great and i power all this off a kenwood mp3 head unit and an i pod through a kenwood interface and the boot speakers are powered by a sony amp under the drivers seat

[Guest BagPuss]

I didn't even think about going for 6x9's, as you say they are too deep for the rear.

The 6" ones I fitted are about the limit with a spacer.

 

I thought the rear tailgate would have a fairly deep cavity but its actually quite shallow.

[Guest gooner52]

do you have a part number on the infinty frnt speakers you used

 

did you use spacers on them also

 

wht watts are they

 

cheers

[cos 4x4]

hi mate there infinity 9603i 3 way speakers fitted on a 30mm spacer if you are thinking of doing this i would have a look in halfors and try and find a shallow fit speaker ie 6x9 or a 6.5" coaxial speaker as the above are just a little too deep but they do sound good amped up