Key Promgraming

[broom broom]

Right here I go again got yet another problem with the bag of bolts ( still not sorted out most of the other stuff!) Ok got a new remote key Went with what the galaxy handbook tells us to do and yet the thing aint working they key is working ok just not remotely any ideas anyone??? :angry:

[NikpV]

1. Close all the vehicle doors.

 

2. Note:

Make sure the door lock cylinder is held in the unlock position for more than 0.5 seconds.

 

Insert the key into the driver door lock cylinder and turn the key from the rest position to the unlock position three times within five seconds.

 

3. The door lock light emitting diodes (LED)s will illuminate for 15 seconds during the remote transmitter programming mode, allowing the remote transmitter to be programmed.

 

4. Remove the key from the driver door lock cylinder and aim the remote transmitter at the interior rear view mirror.

 

5. Press and hold the LOCK button on the remote transmitter.

 

6. While holding the LOCK button down, press the UNLOCK button three times on the remote transmitter.

 

7. Release both buttons simultaneously.

 

8. Make sure the door lock LEDs flash five times, confirming that the remote transmitter has been programmed.

 

9. After a remote transmitter has been successfully programmed, the GEM will reset the programming mode, allowing a further 15 seconds to program the next remote transmitter.

 

10. To program additional remote transmitters, repeat steps 4 to 8.

 

 

is this the procedure you used - does the door led perform at stages 3 and 8

 

(from the faq)