Mondeo Programing Key

[Guest Pauls75]

Hi I no its been on here many times but I cannot find it I have a 1997 Mondeo and the key did not have any batteries in it when I got it I have replaced the batterys and now I need to no how to program it the key has 2 buttons and is black and I do have the red key also I have tried but I cannot ket the red led to stay on I think Im doing it wrong can any one help please the car is 1.8 and its the LX version 16 v Thanks in antisipation Paul ;)

[NikpV]

Assuming its radio based remote for 1997 Mondeo

 

 

A maximum of four keyless entry remote transmitters can be programmed to the central security module. Programming must be done at the same time for all the transmitters.

 

 

To enter programming mode, first verify that the battery is fully charged and the anti-theft system is not armed or triggered (if equipped).

 

Turn the ignition switch from the OFF to the ON position four times within three seconds to enter the learning mode.

 

Turn the ignition switch to the OFF position. The central security module will remain in the learning mode for 20 seconds indicated by the LED in the instrument panel being illuminated continuously.

 

Press any button on the remote transmitter being programmed. When the signal from the remote transmitter, is accepted by the central security module, the LED will flash.

 

To program additional transmitters, repeat step 3, with a 2 second delay after the LED flashes.

 

To exit the learning mode, turn the ignition switch to the ON position. If no transmitter signal is received by the central security module for 20 seconds, the system will automatically exit the learning mode.

 

Test all the programmed transmitters, by activating and deactivating the locking functions.

[NikpV]

If its the infra read remote try

 

 

A maximum of four keyless entry remote transmitters can be programmed to the central security module (CSM). Programming must be done at the same time for all the transmitters.

 

Note:

To enter programming mode, first make sure that the vehicle battery is fully charged and the anti-theft system is not armed or triggered (if equipped).

 

Close all doors and fasten the safety belts to make sure conflicting chimes do not sound during programming.

 

Turn the ignition switch from position I to position II at least four times in six seconds.

 

Turn the ignition switch to position I.

 

The central security module (CSM) is now in the learning mode.

 

Press and hold one of the buttons on the remote transmitter until a chime sounds. This indicates a new transmitter code has successfully received.

 

After each successful programming, another 10 second learning mode is automatically entered, up to a maximum of four times.

 

To program additional transmitters, repeat step 5.

 

The system will leave the learning mode after the ignition switch is turned to position III, or if no new transmitter is programmed during the 10 seconds, or if four remote transmitters have been programmed.

 

An incorrect programming procedure does not affect the stored codes.

 

After successful programming, only the new programmed transmitters will be accepted.

 

Test all the programmed transmitters, by activating and deactivating the locking/unlocking functions.

[Guest Pauls75]

Thanks Nikki I will give it a go :lol:

[NikpV]

Nikki

 

cut out your tougue and cauterise :lol: :D :D :D