chevron169 Posted February 21, 2006 Report Posted February 21, 2006 There is a red and a blue button on the right hand side of the panel that controls the heater/air con temp in my 2.3 Ghia X. These used to illuminate. Does any one know if there's anyway of fixing the lack of light. I know it's trivial compared to some problems I've seen on the site but I'd still like to know if there's an answer. Cheers Quote
Bigjeeze Posted February 21, 2006 Report Posted February 21, 2006 I assume you mean the outer ring that illuminates? If so you can take this off and replace the bulb. I think that you may need to get the bulb from as dealer as it is an encapsulated one - although don't quote me on that!!. You can definitely fix the light. Quote
delboyt Posted February 21, 2006 Report Posted February 21, 2006 i had to replace a bulb for the heater controlsit cost me about Quote
bigdaddy Posted February 21, 2006 Report Posted February 21, 2006 chevron i have the same problem as you,,,,i,managed to open the CC panel,,,and it is a little bulb in a black holder ( the bulb sits in the holder and the wire tags wrap around the holder,,,,very strange set up),,,,,,,,think you need to go to ford for it or get a bulb about 4mm high and 2mm wide with wire tags about 1/2"" long Quote
greg_68 Posted February 21, 2006 Report Posted February 21, 2006 Do they definitely light up as mine don't work either. All the other buttons light up ok. Can't beleive that all of us suffer from just that one bit not lighting up Quote
bigdaddy Posted February 21, 2006 Report Posted February 21, 2006 As far as i could see ,,,, the hot and cold buttons are the only ones with a bulb ,,,, Quote
DaveM Posted February 22, 2006 Report Posted February 22, 2006 from your post, it sounds as though you have climate control and not basic air con, (you mention temperature buttons, not a dial) I'm sure there must be a way of replacing the bulb. i'll watch with interest for when mine goes ! Quote
tedwards Posted February 22, 2006 Report Posted February 22, 2006 Bigdaddy, I have the same problem. How do you access the climate control panel to replace the bulb?. Quote
bigdaddy Posted February 23, 2006 Report Posted February 23, 2006 Remove your radoi,,,,,put your hand in the space,,,,,feel for a little metal clip,,,,,push it upwards and gentle remove the cc unit,,,,,,disconnect the the cable plugs from the rear (its ok,,,,they are colour coded),,,,,,get a very small flat blade screwdriver,,,,,and carefully undo the clips on the front face of the cc unit,,,,,on the circiut board is a black bulb holder,,,, BE CAREFULL ,,,,, AS IT IS ALL DELICATE STUFF,,,,,,,YOU BREAK IT AT YOUR EXPENCE Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.