Guest BigBrian Posted September 10, 2005 Report Posted September 10, 2005 I have tried the following method, but my 1996 'P' 2.0 GLX obviously doesn't follow this sequence:- "Stick the RED key into the ignition switch and turn to position 2 the LED should illuminate, switch the ignition off and remove the key, the LED should go out and then back on again for two seconds, the system is now in the programming mode for the next ten secondsstick the new key in the ignition switch and turn to position 2 The LED will flash once to indicate that the key has been accepted into the system, switch the ignition off and remove the key" When I tried this, after putting the red key in and turning off again the LED did not come back on again for the 2 seconds (it didn't come back on again at all) If I put the new black key in, the LED just keeps flashing all the time PEASE CAN ANYONE HELP Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.