Door Pull Wire End Come Off

[steve alan]

anybody had the end come off the door pull wire and fixed it? if so how?

also how do i get just the bit arrowed in dig out or do i have to take complete lock and outer handel off to get at it?

any help welcomed

thanks in advance

steven

 

 

[attachment=6639:this bit.jpg]

 

 

 

[gregers]

take the door card off.

[steve alan]

done all that just need bit of advice on removing the section or complete lock

[BrianH]

Take door card out

Take outer handle off (theres a screw in the bit on the edge of the door, only visible once door is open) To do this you need to remove the 3 bolts on the end of the lock motor part to allow you to move it about to allow the disconnection of the handle.

 

Once the handle is off from the outside its a case of just removing it - window wants to be up to achieve this, you might have lowered it to help with the door card, so make sure its back up afterwards.

 

Don't think you can do it in situ as most of the lock is covered by plastic casing from memory.

[BrianH]

Further info - the bits labelled 1 and 2 on your diagram are what you need to extract - the one pointing upwards (1) is the bit the handle pulls to open, 2 is the finger part of the lock barrel - known for breaking due to poor design. 3 is the screw i mentioned above that holds the handle in.