Ginettamad Posted August 18, 2009 Report Posted August 18, 2009 My ABS light is on and I found the CV joint tooth ring has come loose and come off the CV. A long story followed re drive shaft bearing needing replacing and garage damaging my car sills but now the new cv is on the ABS light is still on. Does it need to be turned off via a PC VAG Com login? If not then the sensor could haven been damaged by the loose spinning ring? Whats the tecnhique to getting the silly rusted allen bolt out holding the sensor as its bound to snapp off? Would it be best to grind the top off the glue a new sensor on using the thread left to hold the glue? If it snaps it would probably leave the end in the cast hub so can it be drilled right through to put a nut and bolt on instead? Can I get a second hand sensor from a scrappers and re use ok to save funds as I'm skint due to recent problems? Harvey Quote
Ginettamad Posted August 19, 2009 Author Report Posted August 19, 2009 There seem to be some ABS sensors on ebay for around Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.