matt1003

does the rear windows on the opposite side still work ? the 1 touch relays in these are built into the motor so if it is a relay its a new motor anyway ? last time i had this problem it was the wiring in the rubber boot to the door had 3 wires brokern it would go down but not up

if you heard something fall in to the door when you tried to open it chances are the meachanisum is brokern sorry to remove the door panel remove the surround around the door opening handle should be 2 screws remove those then the rest of the panel is on push clips just prise the door card off matt

if all the windows come down about the same level its the total close system which if its doing it when you dont want it to will almost certainly be a probley with one of the front door locks ( even if you use the remote to open and close them ) best way to sort it is wd40 everything to do with locking system inside and outside the door if its just one window i could be a brokern wire in the door rubber ? matt

the sensor for your auto lights and auto wipers is on the windscreen if the screen is dirty it will bring the lights as well matt

the flywheel is part of the torque convertor on a 2.3 auto ( not long changed mine along with the gearbox) torque convertors for them are around

ive tried that in the past i just refuses to start even when you've fixed the problem of why it wouldnt start in the first place just to get its own back on you

if it cut out for no reason and wouldnt start again its either a loose battery wire , a starter motor fuse , the gearstick inhibator switch or relay 30 . if theres no clicking noises when you turn the key chances are its one of the last 2 choices matt

most contaminated clutch pates are caused by either engine oil or gearbox oil the two main seal by the clutch so without taking it apart your mechanic wouldnt know which one it is and if the clutch fuild level is ok the slave cylinder cant be leaking matt

had some of these problems on mine ( reving up an its own cutting out etc ) changed the lamba sensor and it solved most of them matt

do you mean oil light or coil light ? matt

its in the lower part of the front bumber in the grills looks circular with a pin in the middle of it but if you have the climate control on the car it should display the outside temp on there just compare with the weather to see if its about the same matt

did you have it regased at a garage or one of the top up cans , if it was done at a garage they should of checked the centre vent tempratures if the fans come on 10 seconds after the ac is switched on then you should get cold air threw the only other part of the ac system that would stop it getting cold would be the dryer as far as i know ( if it doesnt dry the air enough it doesnt flow round the condenser propley) i know you can do output tests with vag com but has to be registered and not sure about ac tests ( by the way on vag com its auto havc controller sorry ) matt

got the same problem but if the fans dont switch on when you turn a/c on it wont get cold ( this is the problem im having ) vag com controller should be the climatic controller but mine didnt bring any fault codes up ! im going to have a look at the whole car next week so ill let you know if i can find the problem matt

the reason not to lever with a screwdriver is there isnt anything behind the wiper expect a piece of rubber wich goes threw the glass ( which i think you are trying to change ) and glass !! matt

i wouldnt advise the screwdriver on the rear wiper as it goes threw the glass and you might end up with a new window instead just bend it up as if you was changing the blade and wiggle it a little should come of then if not you need something like a bailjoint spliter to free it matt