BRAD

I thought that was the problem as one was seized,so changed both sides,had to cut cups and nut off of shock,so new shocks top bushes and bearings,also replaced bottom ball joint and new drop links as they were apart. Have disconnected steering column as it felt like a joint on that, but that moves freely,so it has to be in the pinion gearing ? Cant see anyone that has taken a rack out,didn't know how much grief it was, as it seems` very tight where pinion goes into bulkhead and subframe. GETTING TO OLD FOR CRAWLING UNDER CARS

I have a bad creaking noise coming from my steering rack on my 2003 galaxy.Have been underneath car when wife turning wheel ,with engine off and sounds like it needs greasing in the pinion gearing. I assume that I will need to change the rack,it seems very tight where the rack goes into car do I need to drop the sub-frame a bit ?

THANKS FOR YOUR HELP..... it was a large broken brown wire and large yellow and red wire in rubber gaiter shorting out. Took the door cad off and pulled the loom out to solder,a real pain getting plug back together, need small hands, had to get the wife out.

You dont leaver it off, you push the door card up to release card from clips as door card brackets are slotted on the underside.

But I dont get how my hazard lights flash once when I press the switch, is there any wires that would short to the hazards. Just look when you lock the car with the key the hazards flash once,so must be short from central locking to that switch ?.

Hi My front drivers side window will not go down on my Mk2, you can hear power going to switch, but when pressing switch up or down it flashes the four way indicators once. Anyone had this problem or how to sollve it , water in somewhere ?.

]The switches are rectangular with round corners to them, I have the silver fascia ,having looked a pictures of Sat Nav fascia they look like square corners in black fascia.

The switches are rectangular with round corners to them, I have the silver fascia ,having looked a pictures of Sat Nav fascia they look like square corners in black fascia. Poped over to Halfords to look at double din units and they are 120mm with the trim,so would have to cut out top and bottom.

Hi All I have been looking at putting double din unit in my 2003 Galaxy. I have looked at Sat Nav option, but the cost of fascia and new switches and going into Ford has put me off of this route Has anyone look at or has cut out the section that is under the cup holders,this would then give me 110mm. I know there would be a bit of bodging required,but not having taken the radio out not to sure about any other problems.

Just got the prices from local Ford for intermediate shaft and also the shaft that it goes into,that goes into the box.

Intermediate shaft on my 03 TD has gone,no drive. Can someone help. Ford,VW,etc.pattern part,price etc.

Thanks for the help.As i didnt know where the connection to the front screen are, i was just going to pull out the main fuse for the screen as i thought this would be the best way to isolate the screen,didnt know it was going to be so difficut to get to.I have also pulled the main fuse to the rear screen 51 and the fuse 19 is still blowing.Havent looked at heated water jet yet or the blowers as i assume the front and rear are on fuse 19.But as stated before part of the screen is not heating and there was a fault on the screen in vag com

Thanks.. but how do you get to that ??? i have stripped the bottom of the dash down and i have it so i can still use the car as is.But cant see the fuses or the relay at the back or are they hidden in the fuse board ???.Sorry for being a pain.

Thank.. that helps,if ive got to go there i could pull out heated front screen relay. I think it could be this as its not heating all the screen and when connected to vag com it had a fault.