ronz

Hi, Changed stat, although nothing was wrong with it, the pump is fine i felt the impeler when I changed the stat and was solid. I think the auxilary heater is working now, I dismatled the run-on pump and the bushes were worn. I get heat to start with but it soon goes cold when the temp hits 90 degrees. I think the blocked heater matrix is right. I really would be so appreciative if anyone can show me photos of where these things are, I just can't find it for the life of me. I read somewhere there is a front and back one, photos would be really appreciated, also any advice how to go about doing it would be great. Do I have to empty all the coolant again? with VAG I get... Address 08: Auto HVAC Labels: 7M3-907-040.lbl Part No: 7M5 907 040 D Component: CLIMATRONIC MPV GP 0003 Coding: 00010 Shop #: WSC 00020 VCID: 3163E91DD1AF 1 Fault Found: 01184 - Rear Vent Outlet Temperature Sensor (G174) 30-00 - Open or Short to Plus Thank you in advance.

Hi, I know this question might have been asked 100 times but can't find answer. I have no heating at all. Aux hasn't worked for a while, other heating stopped at beginning of winter. Car doesn't overheat. Any solutions much appreciated.

Thanks so much Scorpiorefugee for your kindness I really appreciate it.

thanks neil for your post, I really hope this isn't the case I had the same problem last year and had the waterpump checked at the time and was told nothing is wrong with it, it cost me

only code i get is: 01410 - Heater Over-Temp 06-00 - Signal too High

Hi, I have the following code from the VAG-COM: 01410 - Heater Over-Temp 06-00 - Signal too High The problems I have are: Cold air blowing from heating White smoke from auxilary heater exhaust for a few mins Car overheating when going high speeds Anyone know exactly how to solve this please?

tried matt matt's sugestion, no joy :-( i measured the blocks and the following: group 1: 14.4v, 50c, 46c, 50 c group 2: on,on group 3: on,on,off, blower off group 4: pump off then 2 mins later: group 1: 14.4v, 115c, 88c, 98c it stared to rocket to 200c the 115 Any thoughts?

Thanks for this mattmatt, so do you think the glow plug is ok for the aux heater? I'll try your sugestion first thing tomorrow, 50cm is quite high and here in eastanglia hills are no where to be seen, but will try.

i have been there, there is no car better than a galaxy, i would only buy another galaxy, and it will have same problems come up. Recession is here, business is down, well non-existant so finances very limited at the moment. Thats why I realy want to make sure I buy the right part when I do. So any positive diagnostics would be great. I have the following errors from VAG-COM AUX HEATER VAG-COM Version: Release 409.1-US 2 Faults Found: 01410 - Heater Over-Temp 06-00 - Signal too High 01409 - Shareware Version. To Decode all DTCs 35-00 - Please Register/Activate Auto HVAC VAG-COM Version: Release 409.1-US 1 Fault Found: 01184 - Rear Vent Outlet Temperature Sensor (G174) 30-00 - Open or Short to B+ Do these help pin point anything?

Hi, Thanks for all the replies. I cleaned the wiring plugged in the injectors and that seems to have solved the rough running drives nicley. But still have the other problems. - White smoke when cold, could it be the glow plug? - Overheating in high speed, - No heat from heater - i did manage to get heat from heater when it started overheating the car, and even when it went back to 90 it still carried on blowing warm air for over 20 mins till i turned car off. I did have the overheating problem last year, I had changed the thermostat, which wasn't the cause also had a garage check the waterpump which he said was fine and changed the cambelt at same time, mysteriously it started working once he had put it all back together, he didn't say what it was that solved it. There is no coolant loss that i can see, the pressure in the coolant tank is high when i open it in the morning when the car is cold. Any ideas would be great. It has all happened same time :-(

It was the flywheel, the car ran like a dream after changing. But now 1 year on I am having the following problems: - No heat from heater - Overheating in high speed - White smoke when i start the car from the middle of the car - Very rough running, but once the car warms up I can turn off then on and sometimes it runs fine no sluggishness!

I have the following issues: - No heat from heater - Overheating in high speed - White smoke when i start the car from the middle of the car - Very rough running, but once the car warms up I can turn off then on and sometimes it runs fine no sluggishness! I have tried to keep as short as possible, please help any advice would be great. I have read in the forums and thinking it maybe injector wiring look connection or glow plug in aux heater, is that right. If so anyone have pics on how I get to the loom please? Quick advice would be great really need to sort this out asap.

I have the same problem, reading round it could be the water temp sensor. There are 3 diff possible types for my car have to take it out to find out which one but they seem around

Hi All, I had this problem, paniced thinking there is an engine fault. Anyway it was a simple mistake anyone could make, I had changed the brake light for a fog light they look identical i only noticed after looking at the side and nticing it was 4W instead of the 5W it should be. Hope this helps people.

i hope its not the flywheel, I just had a new one fitted which cost