andymet

Hi Finally got around to checking why my Aux heater doesn't work and Vag com can't find it. Found that both clips on the heater that hold the plug in had broken and the plug had come out. Tried just plugging back in and securing with a tie wrap but the plug having been exposed to the elements all winter was badly corroded. Does anyone know if you you can buy the plug and lead and if so where abouts does it plug into the main loom? Any help much appreciated. Andy Met

Hi Almost certainly drive shaft inner cv joint. They have them at europarts for

Remove the headlight assembly, fir the lamps then refit the assembly - 4 torx screws and a connector - so much easier then using the silly flaps that arn't big enough! Just make sure you mark the beam on a wall or garage door first though so you have a reference point when refitting. Much quicker way. Get a 3/4" wide wood chisel. Shine a torch through the little trap door and locate the chisel in the centre groove on the plastic bulb holder. Unscrew anti clockwise then remove the chisel and put you hand in and remove the bulb holder.Reverse to refit. This way takes less the 2 minutes to chenge the bulb. Hope this helps Andy Met

Hi I had the same problem when doing mine. If you undo the two allen screws then get some one to use a lever and put some tension on it pushing it down. While they are doing this get a small sharp chisel and locate it on the join line you are trying to separate. A sharp tap with a hammer and it will spring apart.Hope this helps Andy Met

vw part no 3d0 965 561 d ....wrote this down when i had my pump off to replace brush,s Try your local branch of Andrew Page they are Bosch distributers and cheap

Hi I did a post about 5 years ago detailing how to do it, You should find it in the search. You can use the old nut and bolt and the spacer discs to pull the bearing back into the housing, then its just a case of fitting the circlip and using a soft mallet to gently tap the hub in. You may need to use the bolt and spacers and some packing to pull the bearing to the front of the housing when removing it as it can be difficult to get moving at first with the slide hammer.Hope this helps, Andy Met

Hi The parking sensor control module on my Galaxy has an internal memory fault. (Checked with VAG Com) Does anyone Know anywhere that repairs these units. It seems crazy to have to pay over

Hi Thanks for the suggestions, I've checked all three fuses and they are ok. Vag com says no response from the controller. Now need to check the multi plug. How easy is it to get to? Many thanks for the help so far. Andy Met

Hi Andy 18-Aux Heat is the correct section for the booster heater, what exactly does the message say, are you able to open any other controllers. ie. Engine, central elect, Auto HVAC. Hi Yes I can open other controllers like engine Parking sensors ABS auto HVac etc but 18 and 7D are not found

Hi Can you please tell me which section in vag come the flame out error is listed. I have an unregistered 4.9 verson and looked in both Aux heating sections ut vag com would not find the module. Thanks for any help Andy Met

Hi Do a search on rear wheel bearing and look at my post from July 2005, I did a guide on how to do it Regards Andy Met

Hi Just bring this to the top, any advice would be appreciated.

Hi Car is a 2003 1.9tdi 115 BHP. When acceletating especially with the caravan on I get a vibration mainly bad in second gear. From the searches I've discovered it is probably a drive shaft or the DMF. Checking the drive shaft for play, on the drivers side outer one, there doesn't seem to be any rotational play but longitudinally there is about a quater of an inch. Can someone please confirm if this is knackered? Milage is 126,000. Thanks for any help Andy Met

Hi I phoned up Ford to price a new module it was