Basstromboneist

hi there the best way to do it would be to remove the drive shaft, put in a vice and knock the old joint off then replace with the new one, remember not to do the splines in by hitting the end of the joint back on, use a copper hammer or place a lump of wood between the hammer and the joint, good luck Thanks Roy. I will put this in the memory bank as I have a little man who is going to do this one for me. I would've had a go but for the weather on my drive, it's cold, it's wet, it's cold, its wet, well you get the idea. I just hope the other side holds up till the spring! Thanks again.

Hi all I need to replace CV Joints on my P Reg Mk1 2Lt Advise, instructions, tips, hints and photos would be most welcome.