bruce45

i fitted one of the kits only a couple of months ago and had no problems with it. very easy unplug the connectors going to the light clusters,then plug into the kit and then plug the other end of the kit back into the light cluster. sort of piggy back style.

have been looking at all the posts about this and went for it of Ebay from them and have to say it was much easier to fit than i was expecting. bit off a nack getting the airbag of the steering wheel but managed it. the wiring loom that comes with the kit is for a lhd car so the black that should go to the fuse a long way down the loom, hence them stating that rhd you would have to extend the 4 wires to the ecp. instructions that came with it are really good but if you route it from the steering colum to wards the radio and then with care remove the tape and take out the black wire and retape it and then take the wires for the ecp to the passanger side there is a knock out gromet under the glove box that you can use. you still have to take the battery out and can feed the loom to the ecp top plug behind the water bottle. next snag was getting the connector to bits. took out the clips and then realised you have to lift them up out of the body. small watch makers screw divers to remove the empty connectors and then connected up as the instructions. put it all back together and connected the black to the radio feed switched feed and work without any problems. took about 2 hours to do and used vagcom to set the cruise control to on. only have to seal the knock out off which i am going to use amalgimating tape around the loom and force it into the whole. overall really it easy to install and as long as you take you time and are careful feeding the loom behide the radio when its an really good deal compared to the ford prices. sorry there is no photos never give crossed my mind as it was soooooo easy really

thanks for the info

just to say hi and keep up the good work

thanks for the info