Just changed my door speakers and mumof4 is spot on (on my 2003 at least!) Remove the handle and the 2 (or 3 on drivers door) bolts as described. Make sure you remove the bolts completely, mine didn't fall out so I grabbed them with some pliers. Firmly grab the bottom front (hinge side) of the panel and pull sharply up, repeat at the back, the panel will unclip with no damage to the clips. To refit the panel, check all the wires are refitted or in place. Hang the panel on the panel on the top of the door. With a small amount of pressure in the middle rear edge and bottom of the panel - lift the panel carefully and you will feel the panel locate on the clips. Keeping pressure on the panel, slide down firmly until the panel feels located (may not be fully down). Repeat the lift whilst pressing, locate and slide down on the front edge. - I found the centre bottom location took care of itself - check there is no gap under the middle of the panel. Now press firmly down on the panel frant and back - the panel clicks into place. This worked on all 4 doors, with one door being done a few times whilst measuring and fitting the first speaker. No clips were broken - 1 clip did fall out and was refitted. Hope this helps someone! Thanks again to "mumof4", who saved me from levering the panels off :lol: P.S. Speakers are JBL GTO Series - which I highly recommend for clear and undistorted sound. TIP - look for rubber surrounds and a weather resistant cone (rigid plastic-like material)